0
Owner's of the Panasonic Camcorder Memory Card Camera-Recorder gave it a score of 0 out of 5. Here's how the scores stacked up:
– 32 –
Chapter 3 Recording and Playback — P2 card
- Lift the eject button (Fig. 1), and press in. (Fig. 2)
fmicroP2 memory cards
- Press in the microP2 card further into the camera and let go.
- The microP2 memory card is released from the card slot, and the microP2 memory card can be removed.
@@
NOTE
t After insertion, do not remove the P2 card while it is being accessed or recognized (the P2 card access LED is ashing orange). Doing so may result
in a malfunction.
t If the P2 card is removed while being accessed, [TURN POWER OFF] is displayed on the viewnder screen, and the camera gives out a warning
indication by an alarm, <WARNING> lamp, etc. All P2 card access LEDs ash rapidly in orange. Turn off the power. (page 194)
t If the P2 card is removed while being accessed, clips on it may become irregular. Check the clips and restore them, if required. (page 115)
t If the P2 card being formatted is removed, formatting of the P2 card is not guaranteed. In this case, [TURN POWER OFF] is displayed on the
viewnder screen displays. Turn off the power then back on again, and reformat the P2 card.
t If a P2 card is inserted into another slot during playback, the inserted card is not recognized and the P2 card access LED does not light. The P2 card
starts to be recognized when playback ends.
t Even if a P2 card is inserted in a vacant card slot during recording, the P2 card may not be recognized immediately in the following instance:
- Immediately after a pre-recording
- Immediately after a recording slot is switched
t The P2 card access LED can be set to off at all times in the main menu → [REC/PB] → [REC/PB SETUP] → [ACCESS LED]. In this case, turn off the
power before removing the card, or, after the card is inserted or after operation (recording, playback, etc.) has stopped, and wait for the charging to
complete before removing the card.
Preventing accidental erasure
To prevent the content of a P2 card from being accidentally erased, set the write-protect switch on the P2 card to the Protect (or LOCK) position.
Write-protect switch Write-protect switch
@@
NOTE
t Write-protect switch can be switched while the card is being accessed (during recording or playback), but does not take effect until accessing of the
card stops.
P2 card access LEDs and status of P2 cards
P2 card access LED P2 card status Mode check display*
Is illuminated green Recording possible Reading/writing are both possible. [ACTIVE]
Is illuminated orange Recording target
Reading/writing are both possible. The card is currently
the recording target (including loop recording).
[ACTIVE]
Flashing orange Accessing card Reading/writing are currently being performed. [ACCESSING]
Flashing orange rapidly
The card is being
recognized.
The P2 card is being recognized. [INFO READING]
Flashing green slowly
Card full
There is no free space on the P2 card. Reading only is
possible.
[FULL]
Write protect
The write-protect switch on the P2 card is at the Protect
position. Reading only is possible.
[PROTECTED]
Unrecordable card
Recording is not possible by the currently set recording
format since the SD memory card, etc. is inserted. To
record the card, change the recording format or use a
P2 card.
[REC IMPOSSIBLE]
Slot that is not recording
target
The card is inserted in a slot that is different from the
slot selected in the main menu → [REC/PB] → [REC/PB
SETUP] → [REC MEDIA] ([P2] or [microP2])
No display
Find Your Products By Category
Please Login
