Panasonic Car Video System LCD Video Monitor User Manual

0

Out of 0 Ratings

Owner's of the Panasonic Car Video System LCD Video Monitor gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 80
 
42
43
Main Menu (continued)
FOCUS-IN-RED
FOCUS-IN-RED shows the outline of a subject that is in focus in red to simplify focusing the camera.
Each press of the <FUNCTION1> to <FUNCTION5> button to which the FOCUS-IN-RED has been assigned changes the display.
• To use the FOCUS-IN-RED function, it must be assigned to one of the <FUNCTION1> to <FUNCTION5> functions.
When the FOCUS-IN-RED function is displayed, use the rotary knob <PICTURE> to change detection sensitivity level (1 to 30). A
higher numerical value results in higher detection sensitivity (outlines are displayed in red even when they are not properly focused).
When you set [CHROMA] to [0] or assign [MONO] to another <FUNCTION> button to switch to monochrome, the focus will become
easier to check.
These examples show 16:9 aspect ratio images.
<Note>
• The red of the FOCUS-IN-RED function in the single and 2-screen display modes may differ slightly.
GPI
[GPI CONTROL] is used to enable and disable all GPI functions and assign functions to each of the GPI terminal (→page 60) pins.
Underlined values indicate factory defaults.
Submenu Setting Description
GPI CONTROL
DISABLE
ENABLE
Enables and disables GPI functions
[DISABLE] Disable [ENABLE] Enable
GPI1 to GPI8
UNDEF
MARKER1 ON/OFF
MARKER2 ON/OFF
MARKER BACK HALF
MARKER BACK BLACK
CENTER MARKER
CROSS MARKER
INPUT SEL. VIDEO
INPUT SEL. SDI1
INPUT SEL. SDI2
INPUT SEL. HDMI
INPUT SEL. DVI-I
INPUT SEL. INT-SG
SD ASPECT
SCAN
R-TALLY
G-TALLY
MONO
GAMMA SEL. FILM
GAMMA SEL. STDIO/PST
GAMMA SEL. CINEMA
PIXEL TO PIXEL
FOCUS-IN-RED
ZEBRA
REMOTE STANDBY
Assigns functions to the GPI
input
terminal pins.
The same item can be set to any of the terminals. (For details, refer to
page
60
)
<Note>
• Operation may not be possible depending on the setting conditions.
Example: SD ASPECT operation when input signal is HD
Press the <FUNCTION> button to which the
FOCUS-IN-RED function has been assigned
Normal screen FOCUS-IN-RED display
Press the same
button again
Press the same
button again
The outlines in focus are displayed in red
The foreground is
in focus
The background
is in focus

   Find Your Products By Category