0
Owner's of the Panasonic Car Video System LCD Video Monitor gave it a score of 0 out of 5. Here's how the scores stacked up:
28
Main Menu (continued)
29
Submenu Setting Description
I-P MODE
*
7
MODE1
MODE2
Selects IP conversion mode. (see “IP mode” (→This page).)
[MODE1] Intra-frame interpolation
[MODE2] Intra-field interpolation
MONO
*
2
OFF
ON
Switches between color and monochrome (MONO).
[OFF] Color
[ON] Monochrome
• When [ON], the [CHROMA] setting of the [PICTURE] (picture adjusting) menu is
fixed at 0.
ANAMO
*
8
OFF
ON
With an Anamo lens and HD-SDI input, the picture is resized to Anamo
magnification. (the vertically enlarged signal can be vertically compressed and
corrected for display).
SD ASPECT
*
2
4:3
16:9
Sets the aspect ratio for SD signal input.
[4:3] 4:3 display
[16:9] 16:9 display
SCAN
*
2
*
8
NORMAL
UNDER
Sets under-scan and normal display.
[NORMAL] Normal display
[UNDER] Under-scan
ZEBRA INT. MIN.
*
9
-7% to 108%
(Factory default
setting: 70%)
Sets the range of the ZEBRA function.
Displays the minimum value of the INT. range as a percentage of the video signal.
INT. MAX.
*
9
-6% to 109%
(Factory default
setting: 85%)
Sets the range of the ZEBRA function.
Displays the maximum value of the INT. range as a percentage of the video signal.
EXT. MIN.
*
9
-7% to 108%
(Factory default
setting: 5%)
Sets the range of the ZEBRA function.
Displays the minimum value of the EXT. range as a percentage of the video signal.
EXT. MAX.
*
9
-6% to 109%
(Factory default
setting: 100%)
Sets the range of the ZEBRA function.
Displays the maximum value of the EXT. range as a percentage of the video signal.
*
2
This menu is grayed out when the same item is assigned to GPI and [GPI CONTROL] is set to [ENABLE].
*
7
To use the SUB WINDOW (→page 38) function,
A Change settings after exiting the SUB WINDOW function.
B It is recommended to use [MODE2] for handling fast video.
*
8
[SCAN] changes are not reflected in Anamo size display.
*
9
The ZEBRA function must be set according to the following conditions.
[INT. MIN.] < [INT. MAX.]
[EXT. MIN.] < [EXT. MAX.]
[EXT. MIN.] ≦ [INT. MIN.]
[INT. MAX.] ≦ [EXT. MAX.]
IP mode
[MODE1] performs IP conversion using intra-frame interpolation.
This monitor suppresses the delay to within 1 field.
The factory default is [MODE1].
[MODE2] performs IP conversion using intra-field interpolation.
Since interpolation is performed inside each field, this mode is suitable for checking interlace status.
Find Your Products By Category
Please Login
