0

Out of 0 Ratings

Owner's of the Canon Camcorder Canon XA10 Professional Camcorder gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 191
 
Quick Start Function
48
Quick Start Function
When you close the LCD panel with the camcorder on, the camcorder enters the standby mode. In
standby mode the camcorder consumes only about 1/3 the power used when recording, saving
energy when you are using a battery pack. Additionally, when you open the LCD panel or pull out the
viewfinder, the camcorder is ready to start recording in approximately 1 second*, allowing you to
record the subject right away.
* The actual time required varies depending on the shooting conditions.
1 With the camcorder on and in a recording mode, close the LCD panel.
A beep will sound and the green ON/OFF (CHG) indicator will change to orange to indicate the
camcorder entered standby mode. In addition, the tally lamp will flash twice approximately every
3seconds.
When using only the viewfinder (with the LCD panel closed), you can return the viewfinder to its
retracted position to set the camcorder in standby mode.
2 When you wish to resume recording, open the LCD panel.
The ON/OFF (CHG) indicator turns back green and the camcorder is ready to record.
You can also pull out the viewfinder to start recording with the LCD panel closed.
IMPORTANT
Do not disconnect the power source during standby mode (while the ON/OFF (CHG) indicator is lit
in orange).
NOTES
The camcorder will not enter standby mode while the ACCESS indicator is on or flashing, while a
menu is being displayed or while using the viewfinder. The camcorder may also not enter standby
mode when the battery charge is too low. Check that the ON/OFF (CHG) indicator changes to
orange.
About standby mode and auto power off:
- The camcorder will power off automatically if left in standby mode for 10 minutes. Press x
to turn on the camcorder.
- You can select the length of time until shut-off or turn off the Quick Start function altogether with
the 6 [Power Saving Mode] [Quick Start (Standby)] setting.
- The usual 5-minute auto power off setting of [Power Saving Mode] is not applicable while the
camcorder is in standby mode.
Changing the position of the mode switch while the camcorder is in standby mode will reactivate the
camcorder in the operating mode selected.
Operating modes:
COPY