0
Owner's of the CHIEF Projection Television CHIEF Projection Television gave it a score of 0 out of 5. Here's how the scores stacked up:
LPK1 Installation Instructions
2
DISCLAIMER
Milestone AV Technologies and its affiliated corporations and
subsidiaries (collectively "Milestone"), intend to make this
manual accurate and complete. However, Milestone makes no
claim that the information contained herein covers all details,
conditions or variations, nor does it provide for every possible
contingency in connection with the installation or use of this
product. The information contained in this document is subject
to change without notice or obligation of any kind. Milestone
makes no representation of warranty, expressed or implied,
regarding the information contained herein. Milestone assumes
no responsibility for accuracy, completeness or sufficiency of
the information contained in this document.
Chief® is a registered trademark of Milestone AV Technologies.
All rights reserved.
IMPORTANT SAFETY INSTRUCTIONS
WARNING: A WARNING alerts you to the possibility of
serious injury or death if you do not follow the instructions.
CAUTION: A CAUTION alerts you to the possibility of
damage or destruction of equipment if you do not follow the
corresponding instructions.
WARNING: Failure to read, thoroughly understand, and
follow all instructions can result in serious personal injury,
damage to equipment, or voiding of factory warranty! It is the
installer’s responsibility to make sure all components are
properly assembled and installed using the instructions
provided.
WARNING: Failure to provide adequate structural strength
for this component can result in serious personal injury or
damage to equipment! It is the installer’s responsibility to
make sure the structure to which this component is attached
can support five times the combined weight of all equipment.
Reinforce the structure as required before installing the
component.
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the combined weight of
all components attached to the LPK1 does not exceed 250 lbs
(113.4 kg).
• The weight capacity of the LPK1 may be LIMITED to
the lowest weight capacity of any other components
located between the VCM and the supporting structure!
WARNING: Use this mounting system only for its intended
use as described in these instructions. Do not use
attachments not recommended by the manufacturer.
WARNING: Never operate this mounting system if it is
damaged. Return the mounting system to a service center for
examination and repair.
WARNING: Do not use this product outdoors.
IMPORTANT ! :
The LPK1 mount is designed to be:
• mounted to double 2" x 4" wood stud cross bracing
between two 2" x 4" ceiling joists; or
• mounted to a concrete ceiling with a minimum
thickness of 8" and a maximum drywall covering of
5/8" using 5/16" x 2-1/2" lag bolts (not included) for
Fischer UX8 concrete anchors (not included) or
Toggler AF8 concrete anchors (not included); or
• suspended from four 3/8 in. diameter ASTM A307 or
stronger threaded rods (Threaded rods must have 16
threads per inch - not included) which are secured to a
1-5/8" x 1-5/8" 12ga metal framing strut channel
(spanning a maximum of 4 feet--not included) by ASTM
A307 or stronger 3/8" channel nuts (not included).
• used with a UL Listed Chief VCM projector mount.
--SAVE THESE INSTRUCTIONS--
Find Your Products By Category
Please Login
