0
Owner's of the Kramer Electronics Air Conditioner Kramer Electronics Air Conditioner gave it a score of 0 out of 5. Here's how the scores stacked up:
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Using the WP-211DS
8
5.4 Operating using the Default Master Source Signal Selection
The DEFAULT SELECT switch is factory preset to IN 1 and the WP-211DS
will detect the presence of the master source signal at the XGA INPUT 1
connector. If you connect active sources to both the XGA INPUT 1 and the
XGA INPUT 2 connectors, the source at the XGA INPUT 1 connector takes
priority over the source at the XGA INPUT 2 connector and it is routed to the
XGA OUT and the AUDIO OUT connectors (audio follows the video).
You can change the default so that the WP-211DS automatically detects an
active source signal from XGA INPUT 2, by setting the DEFAULT SELECT
switch to IN 2. When active, the source at the XGA IN 2 connector takes
priority over the source at the XGA INPUT 1 connector and it is routed to the
XGA OUT and the AUDIO OUT connectors (audio follows the video).
If the WP-211DS detects:
No signal
1
at the XGA INPUT 1 input (when INPUT 1 is selected as the
default), the WP-211DS routes the signal from the source at XGA INPUT 2
and AUDIO IN 2 to the XGA OUT and the AUDIO OUT connectors.
Similarly, if the WP-211DS detects no signal at the XGA INPUT 2 input
(when IN 2 is selected as the default), the WP-211DS routes the signal from
the source at XGA INPUT 1 and AUDIO IN 1 to the XGA OUT and the
AUDIO OUT connectors
A signal from the XGA source at XGA INPUT 1 input (when IN 1 is
selected as the default), while routing the signal from the XGA source at XGA
INPUT 2, the WP-211DS will reroute the signal from the XGA source at
XGA INPUT 1 and AUDIO IN 1 to the XGA OUT and the AUDIO OUT
connectors. Similarly, if the WP-211DS detects a signal from the XGA source
at XGA INPUT 2 input (when IN 2 is selected as the default), while routing
the signal from the XGA source at XGA INPUT 1, the WP-211DS will
reroute the signal from the XGA source at XGA INPUT 2 and AUDIO IN 2 to
the XGA OUT and the AUDIO OUT connectors
No signal at all (that is, when there is no active input from a source at
XGA INPUT 1 or at XGA INPUT 2), the WP-211DS will still route XGA
INPUT 2 and AUDIO IN 2 to the XGA OUT and AUDIO OUT connectors,
and continue to examine XGA INPUT 1 input (when IN 1 is selected as the
default), switching back to it when it detects a valid signal. Similarly, if the
WP-211DS detects no signal at all (when IN 2 is selected as the default), it
will still route XGA INPUT 1 and AUDIO IN 1 to the XGA OUT and AUDIO
OUT connectors, and continue to examine XGA INPUT 2 input, switching
back to it when it detects a valid signal
1 Perhaps no source is connected, or that source is connected but its power is OFF
Find Your Products By Category
Please Login
