Ergotron Indoor Furnishings Work Fit D User Manual

0

Out of 0 Ratings

Owner's of the Ergotron Indoor Furnishings Work Fit D gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 14
 
5 of 14
888-24-205-G-03 rev. E • 12/12
8x
1
2
3
ENGLISH
Place the worksurface on a clean  oor with
the top side facing down.
Carefully position the leg with the hand
brake on the right end of the worksurface.
Place the other leg on the left end.
Attach one end of the sync rod to the
right leg as illustrated. Make sure the
brake cables don’t loop around the sync
rod. See Warning, right.
Set-up Steps
NOTE: The brake cable is attached to both legs. Take care when re-
moving the legs from the packaging to avoid damaging or pulling the
brake cable from the legs.
NOTE: Do not fully
insert the screws
into the worksurface
at this time. Leave
approximately 1/8”
space.
Front =2 screws
Middle = 3 screws
Rear = 3 screws
# 12-14 Wood Screw
Front Edge of Worksurface
Rear Edge of Worksurface
Set the right leg (with hand brake) upright on the
worksurface.
Partially insert 3 of the provided #12-14 wood
screws at the rear of the leg, 3 near the middle of
the leg and 2 at the front of the leg.
WARNING
Keep Brake Cables Away from
Sync Rod and Crossbars
During Installation!
Failure to keep the brake cables away from
sync rod and crossbars may restrict lift
motion and may cause equipment damage
or personal injury! Refer to instruction
manual for more information.

   Find Your Products By Category