Ergotron Indoor Furnishings Work Fit D User Manual

0

Out of 0 Ratings

Owner's of the Ergotron Indoor Furnishings Work Fit D gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 14
 
11 of 14
888-24-205-G-03 rev. E • 12/12
=
14mm
14
ENGLISH
Release the hand brake (on the right leg) and move
the worksurface up to highest level.
Push in the cover located behind each leg to access
the adjustment point.
Maintain equal amount of tension on both legs by
alternating the tension adjustment from one leg to
the other using a 14mm socket drill.
Adjustment Step
Spin left to loosen tension
(for lighter loads).
Spin right to tighten tension
(for heavier loads).
Make sure
covers are fully
closed before
lowering the
worksurface.
NOTE: The covers on the legs will not open
unless the worksurface has been lifted to it’s full
height. The worksurface will not lower unless
the covers have been completely closed.
WARNING! DO NOT tip desk over to adjust. Only perform adjustment while desk is upright.
Failure to follow these instructions may cause the lift engine to expand rapidly and may result in
equipment damage and or personal injury.

   Find Your Products By Category