0
Owner's of the Kramer Electronics TV Cables Kramer Electronics TV Cables gave it a score of 0 out of 5. Here's how the scores stacked up:
VS-66HN - Operating the VS-66HN 6x6 HDMI Matrix Switcher
15
6.5 Switching Between Protocol 2000 and Protocol 3000
To switch from Protocol 2000 to Protocol 3000 and vice-versa using the front
panel buttons:
1. Press Output buttons 1 and 3 at the same time.
Protocol 3000 is active.
2. Press Output buttons 1 and 2 at the same time.
Protocol 2000 is active.
Note that when sending consecutive protocol commands make sure to
maintain at least a 200ms delay between commands.
After performing EDID get/store commands, a 1 sec delay is required
before sending another protocol command.
6.6 Connecting via RS-232
You can connect to the VS-66HN via an RS-232 connection using, for example, a
PC. Note that a null-modem adapter/connection is not required.
To connect to the product via RS-232:
Connect the RS-232 9-pin D-sub on the rear panel of the VS-66HN via a
9-wire straight cable (only pin 2 to pin 2, pin 3 to pin 3, and pin 5 to pin 5 need to
be connected) to the RS-232 9-pin D-sub port on your PC
6.7 Connecting via the Ethernet
You can connect to the VS-66HN via Ethernet using either of the following
methods:
Directly to the PC using a crossover cable (see Section 6.7.1)
Via a network hub, switch, or router, using a straight-through cable (see
Section 6.7.2)
Note: If you want to connect via a router and your IT system is based on IPv6,
speak to your IT department for specific installation instructions.
After connecting the Ethernet port, you have to install and configure your Ethernet Port. For
detailed instructions, see the “Ethernet Configuration (FC-11) guide.pdf” file in the technical
support section at http://www.kramerelectronics.com/support/faq.asp.
i
Find Your Products By Category
Please Login
