0
Owner's of the Kramer Electronics TV Cables Kramer Electronics TV Cables gave it a score of 0 out of 5. Here's how the scores stacked up:
KRAMER: SIMPLE CREATIVE TECHNOLOGY
Connecting an Audio/Video Distribution System
8
5 Connecting an Audio/Video Distribution System
To configure a TP-9/TP-10 audio/video distribution system (for example,
for high quality home cinema system), as Figure 5
illustrates, do the following:
1. On the TP-9 connect:
A composite video source (for example, a video player) to the CV
IN BNC connector
A digital audio source (for example, the video player’s audio
signal) to the AUDIO IN S/PDIF RCA connector
The IR OUT 2, 3.5mm mini connector to the IR receiver
1
(on the
video player) via the IR emitter cable (see Figure 4
)
2. On the TP-10, connect the:
CV OUT BNC connector to a composite video acceptor (for
example, a plasma display)
AUDIO OUT S/PDIF (digital audio) RCA connector
2
to an audio
acceptor (for example, the plasma display’s audio connector)
3. Connect the LINE OUT connector of the TP-9 to the LINE IN connector of
the TP-10, via UTP cabling (maximum range of up to 300ft (100m)).
4. On the TP-9 underside, set the VIDEO switch to CV and the AUDIO
switch to S/PDIF.
Note: Do not power the device ON when set to S/PDIF. First set the device
to Analog mode, power on and then switch to S/PDIF if needed.
5. On each TP-9/TP-10 unit, connect a 12V DC power adapter to the power
socket and connect the adapter to the mains electricity (see section 3.1
).
6. On the TP-10, if required, adjust the CV EQ. and level, by inserting a
screwdriver into the small hole and carefully rotating it.
Figure 4: Connecting the IR Emitter
1 Stick the IR emitter to the IR receiver window (usually located on the front panel of the video player)
2 You can also connect either the AUDIO OUT ANALOG 3.5mm mini connector to an analog audio acceptor, or both
AUDIO OUT connectors
IR Emitter
Find Your Products By Category
Please Login
