InFocus Projector IN2126a User Manual

0

Out of 0 Ratings

Owner's of the InFocus Projector IN2126a gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 60
 
30
Timer
Auto Off Time
: automatically turns the projector off after no signals are detected for
a preset number of minutes. If an active signal is received before the projector powers
down, the image will be displayed.
High Altitude Setting
High Altitude: We recommend you turn on the High Altitude Mode when your envi-
ronment is between 5000' (1500m) and 10,000' (3000m) above sea level.
Network
Wired LAN
DHCP: Abbreviation for Dynamic
Host Configuration Protocol. This
protocol automatically assigns IP Addresses to networked devices.
• When the “DHCP” is set to “On”, the DHCP server will assign an
IP address
to the projector automatically. This may take up to a
minute.
• When the "DHCP" is set to "Off", the user will need to set the IP
address manually.
IP Address: The
numerical address used to identify devices on the net-
work. This is only accessible when DHCP is set to Off.
• The IP Address is the number that identifies this
projector on the
network. You cannot have two devices with the same IP Address
on the same network.
• The IP Address “0.0.0.0” is prohibited.
Subnet Mask: A
nume
ric value defining the number of bits used in an IP
Address when the network is divided into subnets. This function can
only be used when DHCP is set to Off.
• The Subnet Mask “0.0.0.0” is prohibited.
Default Gateway:
A se
rver (or router) to communicate across networks
(subnets) that are divided by a Subnet Mask. This function can only be
used when DHCP is set to Off.
DNS: Setup DNS server address when DHCP is disabled.
MAC Address: Abbreviatio
n for Media Access Control Address. A MAC
Address is a unique ID number assigned to each network adapter.
Apply: Save and execute the wired network settings.
Wireless LAN
SSID: Display the projector’s SSID information.
IP
Address: a read-only display of IP Address.
Subnet Mask
: a read-only display of Subnet Mask.
Restart Network...: Restart network settings.
Status/Service:
Source Info: a read-only display of current source settings.
Projector Info: a read-o
nly display of current projector settings.
Reset Lamp Hours...: reset
s the lamp hours used counter in the Projector
Info menu to zero. Do this only after changing the lamp.
Factory Reset...: rest
ores
all settings to their factory default settings.
Service Code...: on
ly used by authorized service personnel.

   Find Your Products By Category