0

Out of 0 Ratings

Owner's of the Azden Microphone Azden Microphone User gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 4
 
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
26
+
+
-
-
Operating the system
Because this is a frequency agile system, the receiver and transmitter must both be on
the same Receive/Transmit frequency. Follow the instructions #5, 16, 24 and 27 carefully.
Make sure both the receiver and the transmitter are on the same channel.
105UPR Receiver
After installing new batteries, mount the receiver to your video camera with the supplied
shoe-mount or hook and loop fastener. Connect the output cable to the receiver and to the
microphone input on the video camera. Switch the 105UPR to “ON” and the power indica-
tor (7) should come on RED. If it doesn’t, check the batteries. When the 105UPR receives
a signal from the transmitter the LED indicator will change to GREEN. If it does not, make
sure both the receiver and the transmitter are on matching Receive/Transmit frequencies.
15BT Transmitter
Plug in the supplied microphone and clip it to your subject. The microphone should be
placed 4-12 inches from your subject’s mouth. Clip the transmitter to a belt using the
supplied belt-clip or place it in a pocket. Switch the 15BT to “ON” and the power indi-
cator should come on. If it doesn’t, check the batteries. Have someone speak into the
microphone as you monitor the sound through the receiver’s phone output. If the sound is
distorted, lower the MIC level on the transmitter. If there is not enough volume, raise the
MIC input level on the transmitter.
15XT Plug-In Transmitter
Switch the transmitter to “ON” and the power indicator should come on. If it does not, check
the batteries. Have someone speak into the microphone as you monitor the sound through
the receiver’s phone output. If the sound is distorted, lower the MIC level on the transmitter.
If there is not enough volume, raise the MIC input level on the transmitter.
15HT Handheld Microphone/Transmitter
Switch the transmitter to “ON” and the power indicator should come on. If it does not, check
the batteries. Have someone speak into the microphone as you monitor the sound through
the receiver’s phone output. If the sound is distorted, lower the MIC level on the transmitter.
If there is not enough volume, raise the MIC input level on the transmitter.
Important Information
Licensing of this, or any Azden wireless equipment is the user’s responsibility. The ability to receive a
license depends largely on the user’s classication, application and frequency. Contact the appropriate
agency (FCC in the US) for further information.
These devices comply with Part 15 of the FCC Rules. Operation is subject to the following two condi-
tions: (1) These devices may not cause harmful interference, and (2( The devices must accept Andy
interference received, including interference that may cause undesired operation.
Note: The manufacturer is not responsible for any radio or TV interference cause by unauthorized modi-
cations to this equipment. Such modications could void the user’s authority to operate the equipment.
These devices and their antenna(s) must not be co-located or operated in conjunction with any other
antenna or transmitter.