Altinex Network Card TILT `N PLUG User Manual

0

Out of 0 Ratings

Owner's of the Altinex Network Card TILT `N PLUG gave it a score of 0 out of 5. Here's how the scores stacked up:

  • Reliability

    0 out of 5

  • Durability

    0 out of 5

  • Maintenance

    0 out of 5

  • Performance

    0 out of 5

  • Ease of Use

    0 out of 5
of 11
 
TABLETOP SOLUTIONS
400-0434-005 2
PRECAUTIONS / SAFETY WARNINGS 1
Please read this manual carefully before using
your Tilt ‘N Plug Jr. Interconnect Box. Keep this
manual handy for future reference. These safety
instructions are to ensure the long life of your
Tilt ‘N Plug Jr. and to prevent fire and shock
hazards. Please read them carefully and heed all
warnings.
1.1 GENERAL
• Unauthorized personnel shall not open the unit
as there are high-voltage components inside.
• Qualified ALTINEX service personnel or their
authorized representatives must perform all
service.
1.2 INSTALLATION PRECAUTIONS
• For best results, place the Tilt ‘N Plug Jr. in a
dry area away from dust.
• To prevent fire or shock, do not expose this unit
to water or moisture. Do not place the unit in
direct sunlight, near heaters or heat-radiating
appliances, or near any liquid. Exposure to
direct sunlight, smoke, or steam can harm
internal components.
• Handle the Tilt ‘N Plug Jr. carefully. Dropping
or jarring can damage the bezel.
• Never place fingers inside the opening on either
side of the unit. This action could cause injury
due to sharp edges inside.
• Do not place heavy objects on top of the
Tilt ‘N Plug Jr. Do not use excessive force to
push down on the top of the unit.
• Disconnect the power cord to turn off the power.
This supplies power to the socket on the pop-up
panel. The power outlet should be installed near
the equipment and be easily accessible.
• We recommend using wall outlets with a
Ground Fault Circuit Interrupter (GFCI) for
maximum protection.
• Install all cables according to the instructions
found herein. Do not force or pull any cable that
is attached to the Tilt ‘N Plug Jr.
1.3 CLEANING
• Surfaces should be cleaned with a dry cloth.
Never use strong detergents or solvents such
as alcohol or thinner. Do not use a wet cloth or
water to clean the unit.
1.4 FCC NOTICE
• This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause
harmful interference, and (2) this device must
accept any interference received, including
interference that may cause undesired
operation.
• This equipment has been tested and found to
comply with the limits for a Class A digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference when
the equipment is operated in a commercial
environment. This equipment generates, uses,
and can radiate radio frequency energy and, if
not installed and used in accordance with the
instructions found herein, may cause harmful
interference to radio communications. Operation
of this equipment in a residential area is likely to
cause harmful interference in which case the
user will be required to correct the interference
at his expense.
• Any changes or modifications to the unit not
expressly approved by ALTINEX, Inc. could void
the user’s authority to operate the equipment.

   Find Your Products By Category