0

Out of 0 Ratings

Owner's of the Panasonic Camcorder Memory Card Camera-Recorder gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 209
 
– 127 –
Chapter 6 Thumbnail Operations for Clips — Thumbnail operations
[TIME] Folder creation time
@@
NOTE
t For [TYPE S] storage devices, you can switch between the partition name and serial name display using the cursor buttons.
t If there is an invalid partition in [P2STORE], the partition information is displayed in gray.
t You can also check the remaining capacity of the target partition in the main menu [CLIP] [PROPERTY] [FREE CAP. OF PARTITION].
Selecting the target folder/partition in the explorer screen
You can display all clips included in the selected partition/folder as thumbnails by selecting partitions/folders as targets. You can display up to six
partitions/folders. When the seventh partition/folder is specied, setting is disabled and a warning is displayed.
1
In the explorer screen, place the cursor on the partition/folder.
2
Press and hold the <SET> button (for one second or more).
The partition/folder is selected and a checkmark is displayed.
The selected target partition/folder is valid until the storage device is disconnected or the power is turned off. To cancel the selected partition/folder,
hold down the <SET> button (for one second or more) again on the selected partition.
Press the <CANCEL> button to deselect all partitions/folders.
@@
NOTE
t In [TYPE S] storage devices, [MODEL] is [UNKNOWN] and clips recorded across other partitions will not be one normal clip. Copying clips to a [TYPE
S] storage device changes the copy destination’s partition [MODEL] to [UNKNOWN].
t The setting of the partition name can be made for the [TYPE S] storage device. The preset partition name is displayed in [PARTITION NAME] on the
explorer screen.
Setting a partition name in the explorer screen
When the storage device is [TYPE S], the name (up to 20 characters) can be set to the partition. The preset partition name is displayed in [PARTITION
NAME] on the explorer screen.
1
In the explorer screen, place the cursor on the partition you want to set up.
You can display the thumbnail list and set a name for the partition by pressing the <SET> button.
2
Press the <MENU> button.
3
Select [CHANGE PARTITION NAME] in the main menu [CLIP] and press the <SET> button.
This displays the soft keyboard.
4
Enter the partition name and select [OK].
The partition name is set.
Deleting the last partition in the explorer screen
You can delete the last partition on a storage device.
1
In the explorer screen, place the cursor on the last partition.
2
Select [DELETE LAST PARTITION] in the main menu [CLIP] and press the <SET> button.
@@
NOTE
t You can only delete the last partition when using a [TYPE S] storage device. You can only delete the last partition. You cannot delete other partitions.
t Since deleted partitions cannot be recovered, perform a check thoroughly before deleting.
Displaying the storage device clip thumbnails and the video monitor
Displaying thumbnails
You can display and manage clips saved in a storage device, as well as display the thumbnail screen for clips saved in a P2 card attached to the
camera.