0

Out of 0 Ratings

Owner's of the Canon Camcorder XF200 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 246
 
83
Adjusting the Focus
English
Manual Focus (MF)
Using the Focus Ring
1 Set the FOCUS switch to M.
A appears on the left of the screen.
2 Turn the focus ring on the lens to adjust the focus.
Focusing speed will depend on how you operate the focus ring.
NOTES
You can use the focus ring to adjust the focus while you are operating
the zoom. If the camcorder was initially in autofocus mode, it will
return to autofocus mode after you adjust the focus manually.
You can change the direction of the adjustment and the sensitivity of
the response of the focus ring using the [w Other Functions] >
[Custom Function] > [Focus Ring Direction] and [Focus Ring Control]
settings (A 141).
Remote Operation Using Browser Remote
After completing the necessary preparations (A 182), you can adjust the focus remotely from a connected
device using the Browser Remote application.
1 If the camcorder is set to AF mode, touch [MF] on the Browser Remote screen.
The gray line in the button will turn orange and the camcorder will change to manual focus mode.
2 Press one of the [FOCUS] controls to adjust the focus as necessary.
Press one of the controls on the [NEAR] side to focus closer or one of the controls on the [FAR] side to focus
farther away.
There are three levels of adjustment - [ ]/[ ] is the smallest and [ ]/[ ] the largest.
NOTES
Using the subject distance display on the screen:
- When the camcorder switches out of autofocus mode or while you adjust the focus with the focus ring, the
approximate subject distance is displayed on the screen for approximately 5 seconds.
- Use the subject distance display as an estimate. When the distance reading is not considered very precise
for a particular zoom range, it will be displayed in gray.
-[G] indicates infinity focus and [G–] indicates over infinity focus.
- You can change the units of distance between meters and feet using the [w Other Functions] > [Custom
Function] > [Distance Units] setting (A 141).
C OPY