0

Out of 0 Ratings

Owner's of the Canon Camcorder XF200 gave it a score of 0 out of 5. Here's how the scores stacked up:
  • Reliability

    0 out of 5
  • Durability

    0 out of 5
  • Maintenance

    0 out of 5
  • Performance

    0 out of 5
  • Ease of Use

    0 out of 5
of 246
 
Connecting to a Wi-Fi Network
176
3 Push the joystick up/down to select the desired access
point and then press SET.
If the access point is encrypted (C), enter the encryption
key (password) with the following procedure. Otherwise,
continue with the procedure to configure the IP address
assignment (A 178).
Encrypted Access Points
1 If necessary, select the WEP index key.
This step is only necessary if the Wi-Fi network’s authentication method is set to [Shared Key] or if the
encryption method is set to [WEP].
2 To enter the [Encryption Key] (password), select [Input] and then press SET.
Enter the password of the selected Wi-Fi network using the keyboard screen (A 176).
3 Continue with the procedure to configure the IP address assignment (A 178).
NOTES
Valid encryption keys vary depending on the encryption method.
64-bit WEP encryption: 5 ASCII characters or 10 hexadecimal characters.
128-bit WEP encryption: 13 ASCII characters or 26 hexadecimal characters.
AES / TKIP encryption: 8 to 63 ASCII characters or 64 hexadecimal characters.
* Note: ASCII characters include the numbers 0 to 9, the letters a to z and A to Z and some punctuation marks and special
symbols. Hexadecimal characters comprise the numbers 0 to 9 and the letters a to f and A to F.
Using the Virtual Keyboard Screen
The virtual keyboard is displayed on the OLED screen.
1 Use the joystick to select a character and then press SET to
add it.
If you are entering sensitive information, like a password, the
character you entered will change to “” after a moment to
protect the password.
Use the arrows (ð/ñ/ò/ó) to change the position of the
cursor and the backspace character () to delete the last
character entered.
Repeat this step as necessary to enter the desired text.
2 After entering the desired text, select [OK] and then press SET to close the keyboard screen.
3 Back in the original screen, select [OK] and then press SET to confirm the text and continue.
Encrypted access point
Current access point/Total number
of active access points detected
Network name (SSID)
Current character / Character limit
C OPY